New site

4 thoughts on “New site”

1. Joe Dunnaway

   28 January 2020

   Hi Gilles… It’s been awhile since I have talked to you.
   I use the Cut (Spar) menu to cut slots for wing tubes in a separate operation after the wing has been cut. This menu always defaults to a square spar and doesn’t save any data entered in the parameters for the spar. Would be possible to save this data with a project. Right now I am saving comments so I can remember what data I need to enter to cut these tube slots.

   Reply
   1. Gilles

      10 February 2020

      Hi Joe,

      You can do that in the EXPERT version

      Reply
2. Wolfgang Watzke

   3 January 2020

   When I am in the Panel Cutting menu and I have decided to cut Left Wing, I would prefere that this choice is kept unless I switched back to Right Wing.
   For me it is irritatig to check the whole time whether or not I am still in Left Wing. It happened sometimes to me that when I want to cut Left Wing that the Right Wing cut was performed instead.
   Is there any possibility to prevent this autmatic return to Right Wing?

   Reply
   1. Gilles

      3 January 2020

      Hi Wolfgang, Yes it could be saved in the project.

      Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.