Posted on 19 October 201819 October 2018 by Gilles — 4 CommentsNew site Welcome on the new GMFC site Post navigationNext post: Merry Christmas and GMFC 4.0.1 4 thoughts on “New site” Joe Dunnaway 28 January 2020 Hi Gilles… It’s been awhile since I have talked to you. I use the Cut (Spar) menu to cut slots for wing tubes in a separate operation after the wing has been cut. This menu always defaults to a square spar and doesn’t save any data entered in the parameters for the spar. Would be possible to save this data with a project. Right now I am saving comments so I can remember what data I need to enter to cut these tube slots. Reply Gilles 10 February 2020 Hi Joe, You can do that in the EXPERT version Reply Wolfgang Watzke 3 January 2020 When I am in the Panel Cutting menu and I have decided to cut Left Wing, I would prefere that this choice is kept unless I switched back to Right Wing. For me it is irritatig to check the whole time whether or not I am still in Left Wing. It happened sometimes to me that when I want to cut Left Wing that the Right Wing cut was performed instead. Is there any possibility to prevent this autmatic return to Right Wing? Reply Gilles 3 January 2020 Hi Wolfgang, Yes it could be saved in the project. Reply Leave a Reply to Wolfgang Watzke Cancel replyYour email address will not be published. Required fields are marked *Comment Name * Email * Website This site uses Akismet to reduce spam. Learn how your comment data is processed.