Posted on Leave a comment

GMFC 4.0.3

It time to release a new version after more than year. I consider version 4.0.3 as a stable one. Please upgrade to this one.

Most of the changes are bug fixes:

  • Improvement in points selection in DXF importation
  • Bug exit spar cutting in separated pass
  • Bug get down surface for closed profile
  • Modification of foam management dialog, move of field C
  • bug postion, horizontal LE in cutting spar & lower surface
  • bug position table+5mm
  • bug pre-heating spar & lower surface
  • Time for stabilizing heat in test cut for foam calibration
Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.